Oxy Acetylene Torch Pressure Chart

Oxy Acetylene Torch Pressure Chart – Step #3 cutting oxygen adjustment procedure set supply pressure for cutting oxygen pressure at supply regulator to approximately 90 psi adjust cutting. Then go across the column for the tip size to the acetylene pressure and oxygen pressure. Adjust the oxygen regulator adjusting screw so the line pressure gauge reads at the intended pressure. Take a look at the.

In order to comfortably and safely see the flame when. Open the torch handle and readjust the oxygen regulator to the. The purpose of the pressure specifications is to ensure proper mixing of the gases for the best quality flame and protect the torch rig from damage and compromised. Increase regulator pressures if longer hose.

Oxy Acetylene Torch Pressure Chart

Oxy acetylene welding set up and pressure settings chart : ** for best results use appropriate capacity torches and 3/8 hose when using tip size 6 or larger. First, we must clean the nozzle because if the head of the nozzle is dirty will cause a flame bad.

Tables show approximate gas pressures for welding or cutting. · ignite flame with striker · increase fuel gas flow until flame leaves end of tip and no smoke is present · decrease until flame goes back to tip · open oxygen valve and adjust to neutral flame · depress oxygen lever and. Cutting torch, preheat pressure is set by the cutting oxygen.

If i want to cut 3/4 inch metal look at the metal size chart and go down do 3/4. It ensures precision, safety, and. Cutting torch tip chart example:

Regulator pressures are for 50 ft (13 m) or less of 3/8 in.

Oxy Acetylene Cutting Pressure Chart